氧化钙对胜利褐煤焦水蒸气气化反应性能及微结构的影响

研究了CaO对胜利褐煤焦水蒸气气化反应性能及微结构的影响。脱除矿物质的胜利褐煤混合不同含量的CaO后在1 100 ℃下进行热解得到相应的煤焦,采用BET、XRD和Raman技术对其进行表征,同时在微型固定床反应器上对所制得煤焦进行水蒸气气化实验。比较添加CaO不同含量煤焦的反应性表明,添加2%(质量分数)的CaO对煤焦水蒸气气化的催化作用很小,而CaO添加量增大到5%时,煤焦的气化反应性能明显提高。煤焦比表面积随CaO添加量的提高而增大。XRD结果表明,在热解过程中,CaO能有效地抑制煤焦向石墨化方向发展趋势。煤焦002和100峰的峰强度随CaO添加量的增加而降低,且煤焦芳香度从66.8%降至39.9%。Raman光谱结果表明,随着CaO添加量的增加,I_D/I_G由1.363增加至1.541,I_G/I_all由0.423减少到0.394。意味着由于Ca的催化作用,煤中大芳香环结构的裂解速率明显增加,且随CaO添加量的增多,煤焦的无序化程度和晶格缺陷均增大。     

Separation of five compounds from leaves of Andrographis paniculata (Burm. f.) Nees by off‐line two‐dimensional high‐speed counter‐current chromatography combined with gradient and recycling elution

An off‐line two‐dimensional high‐speed counter‐current chromatography method combined with gradient and recycling elution mode was established to isolate terpenoids and flavones from the leaves of Andrographis paniculata (Burm. f.) Nees. By using the solvent systems composed of n‐hexane/ethyl acetate/methanol/water with different volume ratios, five compounds including roseooside, 5,4′‐dihydroxyflavonoid‐7‐O‐β‐d ‐pyranglucuronatebutylester, 7,8‐dimethoxy‐2′‐hydroxy‐5‐O‐β‐d ‐glucopyranosyloxyflavon, 14‐deoxyandrographiside, and andrographolide were successfully isolated. Purities of these isolated compounds were all over 95% as determined by high‐performance liquid chromatography. Their structures were identified by UV, mass spectrometry, and ¹H NMR spectroscopy. It has been demonstrated that the combination of off‐line two‐dimensional high‐speed counter‐current chromatography with different elution modes is an efficient technique to isolate compounds from complex natural product extracts.     

“四模块”嵌入下的混合式教学设计与实践*——以功能材料专业物理化学基础课程为例

为建设适应新时代要求,突出高阶性、创新性、挑战度的一流本科课程,实现价值引领、能力培养和知识传授的教育教学目标,结合功能材料专业的特点和民族高等院校学生的学情,构建了物理化学基础课程的“四模块、三阶段、两时空、双平台”的混合式教学新模式,重塑了“价值引领模块、基础理论模块、多学科融合模块和虚拟仿真实验模块”的“四模块”内容体系。通过“四模块”嵌入下的混合式教学实践研究,结合学生的课前、课中、课后等学习成绩,多维度评价学习效果,并藉由调查问卷来分析学生对混合式教学的评价,最终研究结果表明学生的个性化自主学习能力有了显著提高、学生运用物理化学理论解决复杂问题的综合能力得到了提升,学生经过刻苦学习获得了素质提高的成就感。     

超高效液相色谱－四极杆－飞行时间质谱技术非靶向定性筛查猪肉中79种药物残留

利用超高效液相色谱－四极杆－飞行时间质谱（UPLC－Q－TOF MS）建立了猪肉中79种药物残留的非靶向定性筛查方法。猪肉样本采用0.5%（体积分数）甲酸－乙腈溶液先提取,甲醇后提取的组合提取方式,离心后上清液通过FAVEX－NM50兽药残留快速柱净化。以Acquity UPLC BEH HSS－C18色谱柱（2.1 mm × 150 mm,1.7 μm）进行分离,UPLC－Q－TOF MS电喷雾正离子模式电离,全信息串联质谱（MSE）模式检测。79种物质在相应范围内的线性关系良好,相关系数（r2）均不小于0.99,方法的检出限和定量下限分别为0.05 ~ 10 μg/kg和0.10 ~ 20 μg/kg。基于实验室自建质谱数据库,对模拟阳性样本以及市售猪肉样本进行筛查,同时使用高灵敏度Xevo TQ－S串联四极杆质谱多反应监测模式（MRM）对市售猪肉样本进行验证。结果表明,所建立的方法高效、快速、通量高,适用于猪肉中药物残留的筛查和鉴定。     

长庆油田石油磺酸盐中活性组分识别

石油磺酸盐中活性组分的识别对于磺化原料油的选择和磺酸盐产品界面活性的稳定具有重要的指导意义.开展石油磺酸盐关键活性物质结构的确定与活性检测研究,可以提升高品质石油磺酸盐生产的可控性.采用液相色谱制备技术,结合质谱分析和界面张力测试评价,从长庆石油磺酸盐样品中成功分离制备出了具有优异界面活性的关键活性组分.试验结果表明,其活性组分占总石油磺酸盐含量的7.3%,可以将油水界面张力快速降至超低(<1.0×10^(-3) mN/m),且具有广泛的油相普适性,对于正己烷~正十六烷油相以及多种油田来源原油,均可将油水界面张力降至超低.此外,活性组分以单磺酸盐为主,平均相对分子质量为414(不含Na^(+)),相对分子质量分布范围在380~450之间,主要组成是以多种同分异构体结构形式存在的十七烷基苯磺酸盐和十八烷基苯磺酸盐混合物.     

Polypyrrole Hollow Nanotubes Loaded with Au and Fe3O4 Nanoparticles for Simultaneous Determination of Ascorbic Acid,Dopamine, and Uric Acid

An ultrasensitive electrochemical biosensor was fabricated for electroanalytical determination of ascorbic acid(AA), dopamine(DA) and uric acid(UA) individually and simultaneously based on polypyrrole hollow nanotubes loaded with Au and Fe₃O₄ nanoparticles(NPs) uniformly(PPy@Au-Fe₃O₄). The PPy@Au-Fe₃O₄ nanotubes were synthesized in one-pot using MoO₃ nanorods as templates and the polymerization of Py, the formation of Au and Fe₃O₄ NPs and the removel of MoO₃ templates took place stimultaneously. Electrochemical studies reveal that PPy@Au-Fe₃O₄modified glassy carbon electrode(GCE) possesses excellent electro-catalytic activities toward the oxidation of AA, DA and UA. Their oxidation peak currents increase linearly in the concentration ranges of 1-2000 μmol/L for AA, 0.01-25 and 25-300 μmol/L for DA and 0.1-300 μmol/L for UA. Their detection limit values(S/N=3) were calculated as 0.45, 0.0049, and 0.051 μmol/L for AA, DA and UA in the individual detection. By changing the concentrations simultaneously, the calibration curves showed linearity to 1000, 200, and 200 μmol/L with detection limit of 0.39, 0.0060, and 0.060 μmol/L for AA, DA, and UA, respectively. Finally, the obtained biosensor was successfully applied to the detection of AA, DA, and UA with satisfactory results on actual samples.     

二硫化锡纳米片阻变存储器的制备与性能

采用水热法合成了尺寸为50~100 nm的二硫化锡纳米片,并首次以二硫化锡作为阻变层材料的阻变存储器（Cu/PMMA/SnS₂/Ag,PMMA=聚甲基丙烯酸甲酯）,对其阻变性能进行了研究。结果表明： Cu/PMMA/SnS₂/Ag阻变存储器的开关比约10⁵,耐受性2.7×10³。在上述2项性能指标达到较优水平的同时,开态与关态电压分别仅约为0.28与-0.19 V。     

基于二苯甲酰酒石酸构筑的钴（Ⅱ）、镍（Ⅱ）配合物的合成、结构、荧光及磁性质

在室温条件下合成了2个配合物[Ni（DBTA）（DMF）（H₂O）₄]（1）和[Co（DBTA）（DMF）（H₂O）₄]（2）（D-H₂DBTA=D-（+）-二苯甲酰酒石酸,DMF=N,N-二甲基甲酰胺）,并通过元素分析、FT-IR光谱、X射线单晶及粉末衍射表征了2个配合物的结构。X射线单晶衍射结果表明,2个配合物同构,属于单斜晶系,P2₁空间群。配合物由配位键形成零维结构,再通过分子间氢键形成三维网状结构。荧光分析表明当激发波长为280 nm时,配合物1和2具有较强的荧光。尽管2个配合物同构,但表现出不同的磁性质：配合物1主要表现出Ni²⁺离子间弱的反铁磁相互作用,而配合物2则表现为Co²⁺离子的磁各向异性以及Co²⁺离子间强的反铁磁相互作用。     

Large scale synthesis of red emissive carbon dots powder by solid state reaction for fingerprint identification

Red emissive carbon dots(CDs) powder was synthesized on a large scale from phloroglucinol and boric acid by a novel solid state reaction with yield up to 75%. This method is safe and convenient, for it needs neither high pressure reactors nor complicated post-treatment procedures. The as-prepared carbon dots powder exhibited strong red fluorescence with excitation-independent behavior. XPS measurement and PL spectra suggest that such red fluorescence arise from boron-doped structures in CDs, which increases along with the boron concentration on CDs surface but decreases when the concentration quenching effect takes place. To overcome the aggregation induced fluorescence quenching of the solid CDs powder,the conventional methods are dispersing CDs into a large amount of inert substrates. But our present work provides a new strategy to realize strong red fluorescence of CDs in solid state. As a result, such carbon dots powder works well for latent fingerprint identification on various material surfaces.     

添加叔丁醇钾对Mg(NH2)2-2LiH体系储氢性能的影响

叔丁醇钾(C_4H_9OK)的添加显著改善了Mg(NH_2)_2-2LiH体系的储氢性能。添加0.08 mol C_4H_9OK的Mg(NH_2)_2-2LiH-0.08C_4H_9OK样品表现出最佳储氢性能。该样品的起始放氢温度仅为70℃,较Mg(NH_2)_2-2LiH原始样品降低了60℃;130℃完全放氢后,该样品可在50℃开始吸氢,较原始样品降低了50℃。Mg(NH_2)_2-2LiH-0.08C_4H_9OK样品可在150℃的等温条件下50min内迅速放出质量分数3.82%的氢气,完全放氢后可在120℃的等温条件下50 min内快速吸收质量分数4.11%的氢气,表现出良好的吸放氢动力学性能。C_4H_9OK的添加降低了样品放氢反应的表观活化能和反应焓变,改善了放氢反应的动力学和热力学性能,从而降低了放氢反应温度。进一步的放氢反应机理研究发现,在180℃之前,C_4H_9OK对Mg(NH_2)_2-2LiH体系的放氢起催化改性作用;温度继续升高后,C_4H_9OK将会分解并参与放氢反应最终生成Li_3K(NH_2)_4。